Installing a Brick Paver Walkway or Red Wall Bricks

The use of Bricks or Pavers to develop a walkway or outdoor patio matches a home in a way that is unrivaled. In addition, setting up a Brick or Paver walkway does not necessarily need a pro.

The key to installing a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be set up. In addition, string lines need to be strung on each side of the sidewalk.
As soon as the location has been dug down, 3/4" gravel stone should be laid in and tamped down tightly. The height in between the tamped down sand and the stringline need to equate to the thickness of the brick or paver.

Now that you have a stable base, place a 1" pipeline or journal board the length of the pathway on either side of the walkway. Then using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the prepared location. These strips will act as your pathway border and aid to preserve the stability and shape of the walkway.

As soon as this is done, you can then begin to lay the bricks/pavers. There are numerous patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to make sure that they interlock with each other. Always stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again help preserve the integrity of the walkway.

Undoubtedly bricks/pavers will require to be cut or divided when constructing the sidewalk. Unless you wish to purchase or rent an expensive wetsaw, I would recommend purchasing get more info a simple brick/paver splitter. It is basically a chisel with a large end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you wish to break the brick. Utilizing a hammer strike the butt end of the sculpt securely. You may require to do this a number of times. You may also wish to flip the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within a couple of strikes the brick/paver need to break easily. , if your pathway has curves you will require to buy/rent a wetsaw.

.

After setting up the bricks, develop the outdoors edges with extra sand, and then shovel in the topsoil and pack down firmly.
Spread stone dust over the new pathway and sweep into the cracks. This will finish the interlocking of the bricks and help to eliminate any weed growth.


In addition, installing a Brick or Paver walkway does not always require a pro. The key to setting up a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, place a 1" pipe or journal board the length of the sidewalk on either side of the walkway. These strips will act as your pathway border and aid to maintain the integrity and shape of the sidewalk. Inevitably bricks/pavers will require to be cut or divided when developing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *